Wade is helping me troubleshoot the wiring harness. I’m currently running from the Arduino, but the Sanguino is on hot standby. Here is a pic:
Advertisements
Reprap Frustrations
19 01 2009I’m having a tough time getting the Gcode firmware to work on either the Arduino or the Sanguino. The PDE files compile and upload properly, but when I issue a Gcode command through the serial connection, such as “G1 X10”: it does not work, and I get this crazy response:
Comments : 5 Comments »
Categories : Arduino, Gcode, reprap, Sanguino
Electrical system
5 01 2009Here is the reprap electrical system. You can see the prototype reprap motherboard Zach gave me (thanks Zach!):
\
Comments : Leave a Comment »
Categories : reprap, Sanguino
